Table of Contents
Advertisement
Figure 47. Removing the PCIe riser
a. Retract the retaining pin (A) as shown in Figure 47.
b. Lift the PCIe riser from the system.
c. Place the PCIe riser upside down on an ESD surface.
d. Remove the screw and the tail-stock filler for that position.
e. If you are inserting a storage drive adapter, connect the signal cables to the adapter before
inserting the adapter. See "Drive installation information for the 8001-22C system" on page 7 for
cabling information.
NVMe drives are only supported on host operating systems; NVMe drives are not supported by
guest operating systems. On systems with RHEL 7.3 or later, or Ubuntu 16.04 or later, NVMe
drives can be used as bootable drives. Port 1 of the internal NVMe host bus adapter must be
plugged into NVMe port 1 on the disk drive backplane.
f. Insert the PCIe adapter (A) that is located in position 3 into the PCIe adapter riser (B) as shown in
Figure 48 on page 81.
80
Power Systems: Installing the IBM Power System S822LC for Big Data (8001-22C)
Advertisement
Table of Contents
