IBM 8001-22C Manual page 27

Figure 5. Removing a drive
3. If you are installing more than one drive, remove those drive trays.
4. For 3.5-inch drives, remove the plastic filler from the carrier. For 2.5-inch drives in a 3.5-inch
opening, a 2.5-inch tool-less drive carrier exists.
5. Install a drive into the tray. Orient the drive such that the connectors are pointing to the rear of the
drive.
v A 3.5-inch drive fills the tray, as shown in Figure 6 on page 12. Fasten the drive to the sides of the
tray with four screws (two screws on each side).
Installing and configuring the system
11