Lenovo 30A0 Hardware Maintenance Manual page 205

11. Note the orientation of the new microprocessor. Hold the new microprocessor by its edges and align
the notches 1 on it with the tabs
microprocessor straight down into the microprocessor socket.
Note: The small triangle
indicator. The new microprocessor is in the correct orientation when this indicator points to the beveled
4
corner of the microprocessor socket.
Figure 171. Installing the microprocessor
12. Close the microprocessor retainer and lock it into position with the small handle to secure the new
microprocessor in the socket.
13. Reinstall the heat sink and fan assembly with the fan duct as shown. See "Replacing the heat sink and
fan assembly" on page 189.
2 in the microprocessor socket. Then, carefully lower the new
3 on one corner of the new microprocessor is the microprocessor orientation
Chapter 11
.
Replacing FRUs (machine types: 30A2 and 30A3)
199