Accessing The System Board Components And Drives; Installing Or Replacing A Memory Module - Lenovo 30A0 Hardware Maintenance Manual

4. To reinstall the front bezel, align the other three plastic tabs on the bottom of the front bezel with the
corresponding holes in the chassis, then pivot the front bezel inward until it snaps into position.
Figure 95. Reinstalling the front bezel
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 216.

Accessing the system board components and drives

Attention:
Do not open your computer or attempt any repair before reading and understanding "Important safety information"
on page 1.
This section provides instructions on how to access the system board components and drives.
To access the system board components and drives, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Remove the computer cover. See "Removing the computer cover" on page 150.
3. Remove the front bezel. See "Removing and reinstalling the front bezel" on page 151.
4. Remove the heat sink fan duct. See "Replacing the heat sink and fan assembly" on page 189.
5. Press the release tab and pivot the drive bay assembly upward to access the system board components
and the cables.

Installing or replacing a memory module

Attention:
Do not open your computer or attempt any repair before reading and understanding "Important safety information"
on page 1.
This section provides instructions on how to install or replace a memory module.
152
ThinkStation E32 Hardware Maintenance Manual