Note: When the computer is turned on for the first time after replacing the battery, an error message
might be displayed. This is normal after replacing the battery.
10. Turn on the computer and all attached devices.
11. Use the Setup Utility program to set the date, time, and any passwords. See Chapter 6 "Using the Setup
Utility program" on page 55.
Installing the solid-state drive
Attention:
Do not open your computer or attempt any repair before reading and understanding "Important safety information"
on page 1.
This section provides instructions on how to install the 2.5-inch solid-state drive.
To install the solid-state drive, do the following:
1. Install the solid-state drive into the storage converter. Then, install the four screws to secure the
solid-state drive to the storage converter.
Figure 111. Installing the solid-state drive into the adapter
162
ThinkStation E32 Hardware Maintenance Manual