Lenovo 30A0 Hardware Maintenance Manual page 103

7. Slide the new card reader with retainer into the card reader drive bay until it snaps into position.
Figure 26. Installing the card reader
8. Connect the card reader cable to the front USB connector 2 on the system board. See "Locating
parts on the system board" on page 74.
9. Locate the protective cover for the card reader drive bay on the front bezel. Remove the protective
cover by pressing the small tab
cover from the front bezel.
Figure 27. Removing the card reader cover
10. Reinstall the front bezel. See "Removing and reinstalling the front bezel" on page 87.
1 to the left and then pulling the tab to completely disengage the
Chapter 10
.
Replacing FRUs (machine types: 30A0 and 30A1)
97