2. Note the orientation of the socket cover, and install one side of the socket cover into the microprocessor
socket. Carefully press the other side of the socket cover downward until the socket cover snaps
into position.
Note: Your microprocessor socket and cover might look slightly different from the illustration.
Figure 76. Installing the microprocessor socket cover
3. Carefully check the four corners of the socket cover to ensure that the cover is seated securely.
4. Follow any additional instructions included with the replacement part you received.
Replacing the Wi-Fi units
Attention:
Do not open your computer or attempt any repair before reading and understanding "Important safety information"
on page 1.
This section provides instructions on how to replace the Wi-Fi units. The Wi-Fi units include a Wi-Fi adapter
card, a Wi-Fi card module, and a rear Wi-Fi antenna cable.
Replacing the Wi-Fi units involves the following operations:
•
"Removing the Wi-Fi adapter card" on page 136
•
"Removing the Wi-Fi card module" on page 139
•
"Installing the Wi-Fi units" on page 140
Removing the Wi-Fi adapter card
To remove a Wi-Fi adapter card, do the following:
1. Turn off the computer and disconnect all power cords from electrical outlets.
2. Remove the computer cover. See "Removing the computer cover" on page 86.
136
ThinkStation E32 Hardware Maintenance Manual