Replacing The Power Switch - Lenovo 30A0 Hardware Maintenance Manual

9. Insert the connector and cable of the new thermal sensor into the left hole
the two tabs on the plastic holder holding the thermal sensor with the two holes
and press the plastic holder until it snaps into position.
Figure 185. Installing the new thermal sensor
10. Reconnect the thermal sensor cable to the system board. See "Locating parts on the system board"
on page 82.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 216.

Replacing the power switch

Attention:
Do not open your computer or attempt any repair before reading and understanding "Important safety information"
on page 1.
This section provides instructions on how to replace the power switch.
To replace the power switch, do the following:
1. Turn off the computer and disconnect all power cords from electrical outlets.
2. Remove the computer cover. See "Removing the computer cover" on page 150.
3. Remove the front bezel. See "Removing and reinstalling the front bezel" on page 151.
4. Locate the power switch. See "Locating major FRUs and CRUs" on page 79.
210
ThinkStation E32 Hardware Maintenance Manual
1 in the chassis. Then align
1 and 2 in the chassis,