Replacing The Thermal Sensor - Lenovo 30A0 Hardware Maintenance Manual

• To complete the installation or replacement, go to "Completing the parts replacement" on page 216.

Replacing the thermal sensor

Attention:
Do not open your computer or attempt any repair before reading and understanding "Important safety information"
on page 1.
This section provides instructions on how to replace the thermal sensor.
To replace the thermal sensor, do the following:
1. Turn off the computer and disconnect all power cords from electrical outlets.
2. Remove the computer cover. See "Removing the computer cover" on page 150.
3. Remove the front bezel. See "Removing and reinstalling the front bezel" on page 151.
4. Locate the thermal sensor. See "Locating major FRUs and CRUs" on page 79.
5. Press the release tab
Figure 183. Pivoting the drive bay assembly upward
6. Disconnect the thermal sensor cable from the thermal sensor connector on the system board. See
"Locating parts on the system board" on page 82.
208
ThinkStation E32 Hardware Maintenance Manual
1 as shown and pivot the drive bay assembly upward.