Cancel With Fault Code - Miele PG 8593 Operating Instructions Manual

Frequently asked questions

Cancel with fault code

If a program is canceled and a fault code appears, e.g.,
number), there could be a serious technical fault.
In the event of a program being canceled and a fault code being shown:
Use the  button to switch the machine off.

Wait approximately 10 seconds before switching the machine on again with the

 button.
Acknowledge the fault code by entering your PIN code.

Start the previously selected program again.

If the same message appears again:
Make a note of the fault message.

Use the  button to switch the machine off.

Contact Miele Service.

Please also read the notes regarding the following fault codes.
Problem
Fault 403-405
Fault 406–408
Fault 412–414
Fault 422
136
Possible cause and solution
A program has been canceled because water intake by the
machine was insufficient or severely restricted.
Turn on the faucets fully.

Follow the further information provided in the

water intake
message.
A program was canceled because the water flow rate is
insufficient.
Check whether the faucets are fully turned on.

Refer to the information regarding minimum flow

pressure in "Connection to the water supply" and
"Technical data".
Check the filters in the water supply.

In this instance, please contact Miele Service for advice.

A program was canceled because the water flow rate is too
high.
Refer to the information regarding recommended

maximum flow pressure and maximum permissible static
water pressure in "Connection to the water supply" and
"Technical data".
In this instance, please contact Miele Service for advice.

A program was canceled because the conductivity of the
supplied DI water is too high.
Check your system for DI water.

Fault XXX
(where XXX represents a
Check