Table of Contents
Advertisement
Problem solving guide
Cancel with fault number
If a programme is cancelled and a fault number appears, e.g.
represents a number), there could be a serious technical fault.
In the event of a programme being cancelled and a fault number being shown:
Switch the dishwasher off with the button.
Wait approximately 10 seconds before switching the dishwasher on again with the
button.
Start the previously selected programme again.
If the same fault message appears again:
Make a note of the fault message.
Switch the dishwasher off with the button.
Contact the Miele Customer Service Department.
Please also read the notes regarding the following fault numbers.
Problem
Fault F 404–405
Fault F 407–408
Fault F 413–414
Fault F 433
84
Cause and remedy
Check water inlet
If
appears on the display, the control
system is checking the water intake approx. every
30 seconds. If, after three attempts, water is not getting
into the dishwasher, one of these fault numbers will appear
on the display and the programme will be cancelled.
Open the stopcock fully.
Switch the dishwasher off and back on again.
Select the programme you want to use.
Press the Start/Stop button.
Water inlet fault.
If the flow pressure is too low, one of these fault numbers
will appear on the display and the programme will be
cancelled.
The flow pressure at the water connection is too low (see
"Technical data"). Contact the Miele Customer Service
Department for advice.
Water inlet fault.
If the flow pressure is too high, one of these fault numbers
will appear on the display and the programme will be
cancelled.
The flow pressure at the water connection is too high
(see "Technical data"). Contact the Miele Customer
Service Department for advice.
The door was obstructed when closing and cannot be
drawn into the final closed position.
Remove the obstruction from the door closing area.
Fault F XXX
(where XXX
Advertisement
Table of Contents
