Beijer Electronics BoX2 base v2 Configuration Manual page 2

Foreword
This manual contains information about the image/firmware/system program (from now on referred
to as image) and how to get started with the device in the most common applications.
The information in this manual is valid for the latest versions of hardware at the time the manual was
released. All documentation is available in our
Visit Beijer Electronics
Copyright © 2023 Beijer Electronics AB. All rights reserved.
The information in this document is subject to change without notice and is provided as
available at the time of printing. Beijer Electronics AB reserves the right to change any
information without updating this publication. Beijer Electronics AB assumes no responsibility
for any errors that may appear in this document. All examples in this document are only
intended to improve understanding of the functionality and handling of the equipment. Beijer
Electronics AB cannot assume any liability if these examples are used in real applications.
In view of the wide range of applications for this software, users must acquire sufficient
knowledge themselves in order to ensure that it is correctly used in their specific application.
Persons responsible for the application and the equipment must themselves ensure that each
application is in compliance with all relevant requirements, standards, and legislation in respect
to configuration and safety. Beijer Electronics AB will accept no liability for any damage
incurred during the installation or use of equipment mentioned in this document. Beijer
Electronics AB prohibits all modification, changes, or conversion of the equipment.
Head Office
Beijer Electronics AB
Box 426
201 24 Malmö, Sweden
www.beijerelectronics.com / +46 40 358600
SmartStore for image updates and software downloads.
Download center.