Image And Codesys Runtime Update - Beijer Electronics BoX2 base v2 Configuration Manual

Image and CODESYS Runtime Update

4. Image and CODESYS Runtime Update
The device comes pre-loaded with a system image (including firmware and system program).
Images and the Image Loader utility, can be downloaded from the Firmware section in our
SmartStore.
CODESYS is available from the Software section in our SmartStore.
The image/Image Loader utility is used for:
• Updating the image by,
• creating an Image Loader SD card or USB flash drive
• transferring an image to a device through Ethernet
• Updating the CODESYS Runtime by,
• creating an auto-install package for SD card or USB flash drive
• transferring the CODESYS Runtime over Ethernet
In some occasions it is necessary to make a complete system update via Make Recovery SD card.
IMPORTANT
On a BoX2 pro device with image version 2.0 b775 or older, we recommend to update
the image using Make Recovery SD Card. This means that the iX Developer project
and IP settings must be backed up from the device before the image is updated. See
manual MAEN361 chapter 1.2 on how to do the backup.
IMPORTANT
On a BoX2 extreme device with image version older than 2.0 b365, we recommend to
update the image using Make Recovery SD Card. This means that the iX Developer
project and IP settings must be backed up from the device before the image is
updated. See manual MAEN361 chapter 1.2 on how to do the backup.
2023-06 14 Beijer Electronics, MAEN363