Update The Image Using Usb Or Sd Card - Beijer Electronics BoX2 base v2 Configuration Manual

To summarize, the image/CODESYS runtime can be updated in the following ways:
Update method
USB No
SD No
Ethernet No
1
Recovery SD card Yes
1
Only available for image update.

4.1. Update the Image Using USB or SD Card

Do the following:
1. Download your image from Beijer Electronics SmartStore.
2. Unzip the downloaded file and start the Image Loader application.
3. Connect a USB flash drive or SD card to the computer.
In Select drive:, choose the connected USB flash drive or SD card.
4.
Click Create.
5.
6. When finished, eject the USB flash drive or SD card.
7. Connect the USB flash drive or SD card to the BoX2 device and power up the device.
8. Wait until red LED indication starts flashing fast and eject the USB flash drive or SD card.
NOTE
Make sure to eject the USB/SD card. Otherwise, the device will try to update
again during next boot up.
9. The device automatically reboots.
10. Wait until the LED shows a blue status light, or purple on/off every 0.5 seconds (if no iX or
CODESYS project is installed).
The update is now completed.
Beijer Electronics, MAEN363
iX Developer project deleted by
updating
15
Image and CODESYS Runtime Update
IP address reset by updating
No
No
No
Yes
2023-06