Beijer Electronics BoX2 base v2 Configuration Manual page 10

Configuration
Edited content in JSON-file:
{
"Number": "6",
"Enabled": true,
"Command": "LAN B IP",
"Entry": [
"192.168.1.2"
],
"Comment": ""
},
NOTE
"Enabled" must be set to 'true' for the change to take effect.
Several settings can be changed at the same time, but they must all be set to
'true'.
NOTE
Do not change the file name.
3. Put "BoX2ConfigSet.json" on a USB flash drive or SD card and connect it to your BoX2 device.
This will immediately update the network settings. When the change is done the LED on the BoX2
will change temporarily to a red flash.
4. A log file will be created on the USB flash drive, this can be used to verify that the setting was
changed. Example:
"New result file input
Time: 2000-5-28 21:32:37
LAN B set IP: 192.168.1.2
Adapter rebind LAN B successful"
The network settings have been updated.
3.1.2. Using WARP Engineering Studio
WARP can be used to generate a configuration file, in JSON-format, for the BoX2 devices.
The network settings of the BoX2 device will be saved to the file. The file can be stored on, or copied
to, a USB flash drive or SD card, to configure the BoX2 at the first start-up.
2023-06 10 Beijer Electronics, MAEN363