Brother FAX1960C Service Manual page 348

Selector
No.
1 Frame length selection
2 Use of non-standard commands
3
No. of retries
4
5 T5 timer
6 T1 timer
7
Timeout for response from
the called station in
automatic sending mode
8
NOTE: Selectors 1 through 5 are not applicable in those models which do not support ECM.
Selector 1: Frame length selection
Usually a single frame consists of 256 octets (1 octet = 8 bits). For communications lines with higher
bit error rate, however, set selector 1 to "1" so that the machine can divide a message into 64-octet
frames.
Remarks: The error correction mode (ECM) is a facsimile transmission manner in which the
machine divides a message into frames for transmission so that if any data error occurs on the
transmission line, the machine retransmits only those frames containing the error data.
Selector 2: Use of non-standard commands
If this selector is set to "0," the machine can use non-standard commands (the machine's native-mode
commands, e.g., NSF, NSC, and NSS) for communications. If it is set to "1," the machine will use
standard commands only.
Selectors 3 and 4: No. of retries
These selectors set the number of retries in each specified modem transmission speed.
Selector 5: T5 timer
This selector sets the time length for the T5 timer.
Selector 6: T1 timer
This selector sets the time length for the T1 timer.
Selectors 7 and 8: Timeout for response from the called station in automatic sending mode
If the machine (calling station) receives no response (no G3 command) from the called terminal in
automatic sending mode for the period specified by these selectors, it disconnects the line.
WSW09
(Protocol definition 1)
Function
App. 4-13
Setting and Specifications
0: 256 octets
0: Allowed
No. 3 4
0 0 : 4 times
0 1 : 3 times
1 0 : 2 times
1 1 : 1 time
0: 300 sec.
0: 35 sec.
No. 7 8
0 0 : 55 sec. (in U.S.A. and Canadian
60 sec. (in other models)
0 1 : 140 sec.
1 0 : 90 sec.
1 1 : 35 sec.
1: 64 octets
1: Prohibited
1: 60 sec.
1: 40 sec.
models)
sec.: second(s)
Confidential