Brother FAX1960C Service Manual page 179

Assembling Notes
• When securing the power supply PCB, tighten four "i" screws in the order of
shown on the previous page.
• When mounting the power supply shield on the lower MJ/PS shield, route the power supply
harness through the openings "x" and "y" provided in the power supply shield and lower MJ/PS
shield, respectively, as shown on the previous page. And fit the tabs on the power supply shield
into their corresponding slits provided in the lower MJ/PS shield.
Route the power cord as shown below.
• Route the main-MJ (LINE) and (EXT) harnesses through the harness guide as shown below.
Harness guides
Main-MJ (LINE) harness
Main-MJ (EXT) harness
Power supply PCB
Power supply harness
• When mounting the MJ/PS shield unit on the bottom of the lower cover, route the power supply
harness and main-MJ (LINE) and (EXT) harnesses through the lower cover as shown below.
Top view
MJ shield
Ferrite core
PF encoder/
registration
sensor harness
Main-MJ (LINE)
and (EXT) harnesses
Power supply
harness
Lower cover
Ferrite core
Power cord
Cable guide on the lower MJ/PS shield
Cable guide on the MJ shield
Paper feed motor harness
6-37
, , and
(6_34)
(6_34_1)
Confidential
as