9 ] Update The Paper Feeding Correction Value (Function Code 58); 10 ] Align Vertical Print Lines (Function Code 65); 11 ] Margin Adjustment In Borderless Printing (Function Code 66); 12 ] Switch Back To Standby - Brother FAX1960C Service Manual

[ 9 ] Update the paper feeding correction value (Function code 58)

Refer to Section 7.2, [ 5

[ 10 ] Align vertical print lines (Function code 65)

Refer to Section 7.2, [ 6

[ 11 ] Margin adjustment in borderless printing (Function code 66)

Refer to Section 7.2, [ 7

[ 12 ] Switch back to standby

Refer to Section 7.2, [ 9

[ 13 ] Register cordless handsets

On the cordless handset
(1) Press the Menu/OK key.
(2) Press the
The cordless handset enters the registration mode.
On the machine (base unit)
Complete steps (3) and (4) below within two minutes from the entry of the registration mode.
(3) Press the Menu, 0, 6, and OK keys in this order.
(4) Press the
Upon successful end of registration, the machine sounds a long beep.
Notes • If the machine sounds three short beeps, indicating the failure of registration, it returns to
the "Register" state. Perform steps (1) through (4) again.
• If you want to install another cordless handset, repeat steps (1) through (4).
• Up to four cordless handsets can be registered to the machine.
(5) Press the Stop/Exit key. The machine returns to the standby state.
].
].
].
].
or key to choose "Register HS," then press the Menu/OK key.
or key to display "Register," then press the OK key.
7-29
Confidential