the vehicle may get dirty.
18Temporarily store the bottle
in the luggage compartment
while it is connected to the
compressor.
19To spread the liquid sealant
evenly within the tire, imme-
diately drive safely for about
3 miles (5 km) below 50 mph
(80 km/h).
20After driving, stop your vehi-
cle in a safe place on a hard,
flat surface and reconnect
the repair kit.
Remove the air release cap from
the hose before reconnecting the
hose.
21Turn the compressor switch
on and wait for several sec-
7-2. Steps to take in an emergency
onds, then turn it off. Check
the tire inflation pressure.
If the tire inflation pressure is
A
under 19 psi (130 kPa, 1.3
kgf/cm
cannot be repaired. Contact
your Toyota dealer.
If the tire inflation pressure is
B
19 psi (130 kPa, 1.3 kgf/cm
or bar) or higher, but less
than the specified air pres-
sure: Proceed to step 22.
If the tire inflation pressure is
C
the specified air pressure
(P.524): Proceed to step
23.
22Turn the compressor switch
on to inflate the tire until the
specified air pressure is
reached. Drive for about 3
miles (5 km) and then per-
form step 20.
23Attach the air release cap to
the end of the hose.
If the air release cap is not
attached, the sealant may leak and
2
or bar): The puncture
491
2
7
OwnersManuals2.com