300
4-5. Using the driving support systems
WARNING
●
Do not subject the camera vicin-
ity to strong impacts. If the vicin-
ity is subjected to a strong
impact, have the vehicle
inspected by your Toyota
dealer.
Do not disassemble, remodel or
●
paint the camera.
●
Do not attach accessories or
stickers to the camera.
●
Do not install market protection
parts (bumper trim, etc.) to the
rear bumper.
●
Maintain suitable tire air pres-
sure.
●
Make sure the back door is
completely closed.
■
RCD function is turned off
In the following situations the sys-
tem turns off. The RCD function
may not operate properly and
thus there is the danger that an
accident may occur.
●
The contents mentioned above
are not observed.
●
Suspensions other than genu-
ine parts are installed.
System components
Location of the rear camera
■
Depending on the vehicle grade
and equipped options, the actual
rear camera may be different from
this illustration.
RCD display
A
Pedestrian detection icon
Displayed automatically when a
pedestrian is detected behind the
vehicle.
Turning the RCD function
on/off
The RCD function can be
enabled/disabled on
multi-information display.
(P.538)
When the RCD function is disabled,
the driving assist information indi-
cator (P.84) illuminates, and a
message is displayed on the multi-
information display.
Each time the power switch is
turned off then changed to ON, the
RCD function will be enabled auto-
matically.
of the
OwnersManuals2.com