Toyota PRIUS 2023 Manual page 384

384
5-4. Using the other interior features
■ The wireless charger can be
operated when
The power switch is in ACC or ON.
■ Usable smartphones
● Qi standard wireless charge stan-
dard can be used on compatible
devices. However, not all Qi stan-
dard devices and compatibility are
guaranteed.
● This product is designed for use
with smartphones with a power
supply of 5 W or less.
However, charging exceeding 5 W
●
is supported by the following
smartphones.
• Charging at 7.5 W or less is sup-
ported by iPhone's that support
7.5 W charging.
• Charging at 10 W or less is sup-
ported by smartphones compliant
with EPP output as defined by
WPC standard Ver1.2.4.
■ Using the smart key system
Charging will be suspended for the
smart key system to detect the elec-
tronic key during charging such as
when the electronic key has been
brought outside the vehicle. When
the electronic key is detected,
charging will automatically start
again.
■ When covers and accessories
are attached to smartphones
Do not charge in situations where
cover and accessories not able to
handle Qi are attached to the smart-
phone. Depending on the type of
cover (including for certain genuine
manufacturer parts) and accessory,
it may not be possible to charge.
When charging is not performed
even with the smartphone placed on
the charge area, remove the cover
and accessories.
■ Noise enters the AM radio while
charging
● Turn off the wireless charger and
confirm that the noise has
decreased. If the noise
decreases, continuously pushing
the power supply switch of the
wireless charger for 2 seconds,
the frequency of the charger can
be changed and the noise can be
reduced.
Also, on that occasion, the opera-
tion indicator light will flash orange
2 times.
● iPhone's use a particular fre-
quency for rapid charging.
Depending on the iOS version,
rapid charging may not be per-
formed while switching frequen-
cies.
■ Important points of the wireless
charger
● If the electronic key cannot be
detected within the vehicle inte-
rior, charging cannot be done.
When the door is opened and
closed, charging may be tempo-
rarily suspended.
● When charging, the wireless
charging device and smartphone
will get warmer, however this is
not a malfunction.
When a smartphone gets warm
while charging, charging may stop
due to the protection function on
the smartphone side. In this case,
when the temperature of the
smartphone drops significantly,
charge again.
■ Cleaning the wireless charger
P.402
■ Situations in which the function
may not operate normally
Devices may not be charged nor-
mally in the following situations.
● The smartphone is fully charged
● The smartphone is being charged
with a cable connected
● There is foreign matter between
the charge area and smartphone
● Charging has caused the smart-
phone to heat up
OwnersManuals2.com