Table of Contents
Advertisement
the buffers are empty, a "start" signal can be sent to re-start the flow. Hardware
flow control uses two wires to send start/stop signals.
The optional settings: [None]; [Hardware RTS/CTS].
VT-UTF8 Combo Key Support
Use this item to enable VT-UTF8 Combination Key Support for ANSI/VT100
terminals.
The optional settings: [Disabled]; [Enabled].
Recorder Mode
With this mode enable only text will be sent. This is to capture Terminal data.
The optional settings: [Disabled]; [Enabled].
Resolution 100x31
Use this item to enable or disable extended terminal resolution.
The optional settings: [Disabled]; [Enabled].
Putty KeyPad
Use this item to select Function Key and KeyPad on Putty.
The optional settings: [VT100]; [LINUX]; [XTERMR6]; [SCO]; [ESCN]; [VT400].
Legacy Console Redirection Settings
Press [Enter] to make settings for the following items:
Redirection COM Port
Use this item to select a COM port to display redirection of Legacy OS and Legacy
OPROM Messages
The optional settings: [COM1]
Resolution
Use this item to on legacy OS, the number of rows and columns supported
redirection
The optional settings: [80x24]; [80x25]
Redirect After POST
When bootloader is selected, then legacy console redirection is disabled before
booting to legacy OS. When always enable is selected, the legacy console
redirection is enabled for legacy OS. Default setting for this option is set to always
enable.
The optional settings: [Always Enable]; [BootLoader]
41
Advertisement
Table of Contents
