JETWAY MI215 Series User Manual page 43

Use this item to enable or disable serial port (COM).
The optional settings: [Disabled]; [Enabled].
Change Settings
Use this item to select an optimal setting for super IO device.
The optional settings are: [IO=3E0h; IRQ=11]; [IO=3F8h; IRQ=3,4,5,7,10,11];
[IO=2F8h; IRQ=3,4,5,7,10,11]; [IO=3E8h; IRQ=3,4,5,7,10,11]; [IO=2E8h;
IRQ=3,4,5,7,10,11]; [IO=3E0h; IRQ=3,4,5,7,10,11]; [IO=2E0h; IRQ=3,4,5,7,10,11];
 Serial Port 6 Configuration
Press [Enter] to make settings for the following items:
Serial Port
Use this item to enable or disable serial port (COM).
The optional settings: [Disabled]; [Enabled].
Change Settings
Use this item to select an optimal setting for super IO device.
The optional settings are: [IO=2E0h; IRQ=11]; [IO=3F8h; IRQ=3,4,5,7,10,11];
[IO=2F8h; IRQ=3,4,5,7,10,11]; [IO=3E8h; IRQ=3,4,5,7,10,11]; [IO=2E8h;
IRQ=3,4,5,7,10,11]; [IO=3E0h; IRQ=3,4,5,7,10,11]; [IO=2E0h; IRQ=3,4,5,7,10,11];
WatchDog Reset Timer
Use this item to support WDT reset function.
The optional settings: [Disabled]; [Enabled].
When set as [Enabled], the following sub-items shall appear:
WatchDog Reset Timer Value
User can set a value in the range of [4] to [255].
WatchDog Reset Timer Unit
The optional settings are: [Sec.]; [Min.]
ATX Power Emulate AT Power
This item support Emulate AT power function, MB power On/Off control by power
supply. Use needs to select 'AT or ATX Mode' on MB jumper at first (refer to
JAT_ATX jumper setting Pin 1&2 of for ATX Mode & Pin 2&3 of AT Mode Select).
Case Open Detect
Use this item to detect case has already open or not, show message in POST.
The optional settings: [Disabled]; [Enabled].
38