Band Isolator - Roland VS-2400CD Appendices

3band Isolator

Sharply cuts off components by frequency band to eliminate undesired sounds. Useful to eliminate undesired
sounds and take out only specific sounds from a CD. Isolator can make sounds completely perish, unlike ordinary
equalizers that leave some sounds even with the gains of the respective frequency bands set to the minimum.
fig.08-69
Input L
Input R
Muting the bass
Set up as follows to eliminate low frequency band sounds such as bass sounds.
Anti-phase Low Mix Switch (AntiPhase LoMixSw): On
Anti-phase Low Level (AntiPhase LoLev):
Muting vocals
Set up as follows to eliminate middle frequency band sounds such as vocal sounds.
Anti-phase Middle Mix Switch (AntiPhase MidMixSw): On
Anti-phase Middle Level (AntiPhase MidLev):
Muting noise
Identify the frequency band of the noise and set the relevant Level (LowLvl, MidLvl or HiLvl) to -60 dB.
Parameter (full name)
Iso (3-band Isolator):
Sw (Switch)
AntiPhase LoLev (Anti-phase Low Level)
AntiPhase MidLev (Anti-phase Middle Level)
LoMixSw (Anti-phase Low Mix Switch)
MidMixSw (Anti-phase Middle Mix Switch)
LowLvl (Low Level)
MidLvl (Middle Level)
HiLvl (High Level)
Output L
3 Band
Isolator L
3 Band
Isolator R
Output R
Setting
Divides the input sound into three frequency bands to abstract or eliminate the
sound.
On, Off
0–100
0–100
On, Off
On, Off
-60– +4 dB
-60– +4 dB
-60– +4 dB
Relatively High
Relatively High
Function
Turns the 3-band isolator on or off.
Sets the amount of the low frequency band sound should
be muted.
Sets how much of the middle frequency band sound should
be muted.
Mutes or leaves the low frequency band sound.
Mutes or leaves the middle frequency band sound.
Increases or decreases frequency bands in the low
frequency band.
Increases or decreases frequency bands in the middle
frequency band.
Increases or decreases frequency bands in the High
frequency band.
Algorithm List
87