Voice Transformer - Roland VS-2400CD Appendices

Algorithm List

Voice Transformer

You can convert male voice into female voice, female voice into male voice, and human voice into mechanical
voice to create sounds of various qualities by controlling the base pitch and the formant separately.
fig.08-63
Input L
Input R
• When inputting voice, use voice of one person only. Inputting voices of more than one person disables normal
operation.
• Be sure that sound from a speaker does not enter the microphone you are using. This will have the same effect
as if several voices were input to the unit.
• A undirectional microphone is recommended for use. It is also recommended that the person should speak
standing as close to the microphone as possible.
• "Voice Transformer" cannot be used on EFFECT2 and 4 (even-numbered effects).
• When "Voice Transformer" is used on EFFECT1 and 3 (odd-numbered effects), EFFECT2 and 4 (even-numbered
effects) cannot be used.
• "Voice Transformer" cannot be used on the projects with 64kHz or higher sampling rate.
Parameter (full name)
VT (Voice Transformer):
Sw (Switch)
Robot (Robot)
Chromatic Pitch
Fine Pitch
Chromatic Formant
Fine Formant
MixBal (Mix Balance)
REV (Reverb):
Sw (Switch)
Time (Reverb Time)
PreDLY (Pre-Delay)
Densty (Density)
FX Lvl (Effect Level).
Formants (p.18)
80
Voice
Transformer
Setting
Creates various voice characters.
On, Off
On, Off
-12– +36
-100–100
-12– +12
-100– +100
0–100
Adds reverberation.
On, Off
0.1–32.0 sec
0–200 ms
0–100
0–100
Output L
Reverb
Output R
Function
Turns Vocal the transformer on or off.
When this is on, the audio will be output at a fixed pitch
regardless of the pitch that is input.
Sets the pitch variation of the voice to be output (by
semitone).
Sets the pitch variation of the voice to be output (by cent).
Sets the formant variation of the voice to be output (by
semitone).
Sets the formant variation of the voice to be output (by
cent).
Sets the volume balance between the output voice and the
input voice.
Turns the reverb on or off.
Sets the length (time) of the reverb sound.
Sets the time until the reverberation appears.
Sets the density of the reverb sound.
Sets the volume of the reverb sound.