Roland VS-2400CD Appendices page 49

Parameter (full name)
Rev (Reverb 2):
Sw (Switch)
Type (Reverb Type)
Gate (Gate)
Mode (Gate Mode)
Time (Reverb Time)
PreDLY (Pre-Delay)
Densty (Density)
HPF (High Pass Filter)
LPF (Low Pass Filter)
Thresh (Threshold)
Attack (Attack)
Releas (Release)
HoldT (Hold Time)
FX Lvl (Effect Level).
DirLvl (Direct Level)
EQ (Equalizer)
Sw (Switch)
Low Gain (Low Gain)
Low Freq (Low Frequency)
Low Q
Low Type
Mid Gain (Middle Gain)
Mid Freq (Middle Frequency)
Mid Q (Middle Q)
High Gain
High Freq (High Frequency)
High Q
Hi Type (High Type)
Level (Output Level)
*1: If Low Type (Lo Type) or High Type (Hi Type) is set to "Shlv (Shlving Type)," the setting for Lo Q or High Q is
invalid.
Setting
Gate reverb with two modes of gate operation
On, Off
See the column on
the previous page.
On, Off
Gate, Ducking
0.1–10.0 sec.
0–200 ms
0–100
Thru, 20 - 2000 Hz
1.0–20.0 kHz, Thru
0–100
1–100
1–100
1–100
0–100
0–100
On, Off
-12– +12 dB
20 - 2000 Hz
0.3–10.0
Shlv, Peak
-12– +12 dB
200–8000 Hz
0.3–10.0
-12– +12 dB
1.4–20.0 kHz
0.3–10.0
Shlv, Peak
0–100
Function
Turns the reverb on or off.
Sets the reverb type.
Opens or closes the gate.
Sets the gate operation type.
Sets the length (time) of the reverb sound.
Sets the time until the reverb sound is output.
Sets the density of the reverb sound.
Sets the frequency at which HPF starts taking effect.
Set this to "Thru" if HPF is to be disabled.
Sets the frequency at which LPF starts taking effect.
Set this to "Thru" if LPF is to be disabled.
Sets the reference volume for controlling gate operations.
Sets the time from when the direct sound level exceeds the
threshold level until when the gate is completely open.
Sets the time from when the hold time has elapsed until the
sound is completely muted.
Sets the time from when the input falls below the threshold
level until when the release begins.
Sets the volume of the reverb sound.
Sets the volume of the direct sound.
Turns the equalizer on or off.
Sets the boost/cut amount in the low frequency band.
Sets the center frequency in the low frequency band.
Sets the width of the area around the low frequency that
will be affected by the gain settings.1
Sets the type of the low frequency band equalizer
(Shlving type or peaking type).
Sets the boost/cut amount in the middle frequency band.
Sets the center frequency in the middle frequency band.
Sets the width of the area around the middle frequency that
will be affected by the gain settings.
Sets the boost/cut amount in the High frequency band.
Sets the center frequency in the High frequency band.
Sets the width of the area around the High frequency that
will be affected by the gain settings.1
Sets the type of the High frequency band equalizer (Shlving
type or peaking type).
Sets the volume after passing through the equalizer.
Algorithm List
*1
*1
49