Roland VS-2000 Appendices page 32

Algorithm List
Chorus RSS
RSS (p. 37) is connected to the Chorus output. The sound image is defined with the sound from the left-side channel located at left
90˚ and the sound from the right-side channel at right 90˚.
fig.08-22
Input L
Input R
• Location is fixed; no azimuth or elevation can be specified.
• Refer to the column "Labeling on RSS product package" (p. 38).
Parameter (full name)
ChoRSS (Chorus RSS)
Rate (Chorus Rate)
Depth (Chorus Depth)
FX Lvl (Effect Level)
DirLvl (Direct Level)
Phones (Phones)
*1 Refer to the column "Precautions for using RSS" (p. 38).
Space Chorus
This is a chorus effect simulating Roland SDD-320. The effect to be changed can be reproduced by turning the four buttons 1 to 4
on or off.
fig.08-51
Input L
Input R
Parameter (full name)
Spcho (Space Chorus):
Sw (Switch)
InMode (Input Mode)
Mode (Space Mode)
MixBal (Mix Balance)
32
Direct Level
Chorus
Direct Level
Setting Function
: Locates chorus sounds three-dimensionally.
0.1–10.0 Hz Sets the rate of modulation.
0–100 Sets the depth of modulation.
-100–100 Sets the volume of the chorus RSS sound.
-100–100 Sets the volume of the direct sound.
Off, On Set to On when you use headphones
Set to Off when you use speakers
Output L
Space Chorus
Output R
Setting Function
Adds a chorus effect simulating SDD-320.
On, Off Turns the space chorus on or off.
Mono, Stereo Specifies whether the input signal is stereo or mono.
1, 2, 3, 4, 1+4, 2+4, 3+4 Sets the chorus variation style.
0–100 Sets the volume balance between the chorus sound and the direct sound.
RSS
RSS
Output R
Output L
*1