Roland VS-2000 Appendices page 30

Algorithm List
Multi Tap Delay
This is a Delay feature that can set 10 delay sounds separately.
fig.08-45
Input L
Input R
Parameter (full name)
MTD (Multi-Tap Delay):
Time Ch1 – Ch10 (Delay Time 1 – 10)
Level Ch1 – Ch10 (Delay Level 1 – 10)
Pan Ch1 – Ch10 (Pan 1 – 10)
FBTim (Feedback Delay Time)
FBLvl (Feedback Level)
FX Lvl (Effect Level).
DirLvl (Direct Level)
EQ (Equalizer)
Sw (Switch)
Low Gain (Low Gain)
Low Freq (Low Frequency)
Low Q
Low Type
Mid Gain (Middle Gain)
Mid Freq (Middle Frequency)
Mid Q (Middle Q)
High Gain
High Freq (High Frequency)
High Q
Hi Type (High Type)
Level (Output Level)
*1: If Low Type (Lo Type) or High Type (Hi Type) is set to "Shlv (Shlving Type)," the setting for Lo Q or High Q is invalid.
30
Direct Level
Pan 1
Pan 2
Pan 10
Multi Tap Delay
Feedback Level
Direct Level
Setting Function
Issues 10 delay sounds separately.
0–1200 ms Sets the time from the direct sound until when the delay sound for channels 1–10 is heard.
0–100 Sets the volumes of delay sounds for channels 1–10.
L63–R63 Sets the pan of the delay sounds for channels 1–10.
0–1200 ms Sets the repetition frequency for feedback.
-100–100 Sets the amount of the delay sound should be returned to the delay input.
-100–100 Sets the volume of the delay sound.
-100–100 Sets the volume of the direct sound.
On, Off Turns the equalizer on or off.
-12– +12 dB Sets the boost/cut amount in the low frequency band.
20 - 2000 Hz Sets the center frequency in the low frequency band.
0.3–10.0 Sets the width of the area around the low frequency that will be affected by the gain settings.
Shlv, Peak Sets the type of the low frequency band equalizer (Shlving type or peaking type).
-12– +12 dB Sets the boost/cut amount in the middle frequency band.
200–8000 Hz Sets the center frequency in the middle frequency band.
0.3–10.0 Sets the width of the area around the middle frequency that will be affected by the gain settings.
-12– +12 dB Sets the boost/cut amount in the High frequency band.
1.4–20.0 kHz Sets the center frequency in the High frequency band.
0.3–10.0 Sets the width of the area around the High frequency that will be affected by the gain settings. *1
Shlv, Peak Sets the type of the High frequency band equalizer (Shlving type or peaking type).
0–100 Sets the volume after passing through the equalizer.
Output L
3BAND EQ
3BAND EQ
Output R
*1