Error Messages - Roland VS-2000 Appendices

Error Messages

■ Aborted Command!
This disk drive cannot be used by the VS-2000.
■ Arbitration Failed!
The disk drive could not be accessed. Make sure that the disk drive is connected correctly.
■ AUTOMIX: Event Memory Full!
The project already contains all of the events it can hold. Delete unneeded automix data or perform a Project Optimize
operation.
■ Blank Disc
The CD in your drive is blank. Insert a CD or CD-R/RW that contains recorded material.
■ Cannot write in "Track at Once" format on CD-RW Disc!
You have tried to write the audio data in "Track at Once" format with a CD-RW disc in the drive.
■ Can't Communicate!
There is a problem with your disk drive connection. Make sure the disk drive is connected correctly.
■ Can't Set Marker!
Track number markers must be at least four seconds apart.
■ Can't record CD!
Digital recording from a CD player is not enabled. Please read "Recording Digital Input Signals" (Owner's Manual).
■ CD-RW Memory Full!
There is not enough room on the CD-R/RW disc.
■ Check Condition!
The disk drive could not be accessed. Make sure that the disk drive is connected correctly.
■ DIGITAL In Lock
The sample rate reference clock is set by the digital signal received at the COAXIAL IN connector as shown above. You can
now record the digital signal.
■ DIGITAL In Unlock Change to Internal Clock?
You cannot yet record the incoming digital audio because it is not being received by the COAXIAL IN connector as shown
above, or because the project sample rate (44.1kHz) and the sample rate of the digital device connected to the COAXIAL IN are
different.
Switch the sample rate reference clock to the VS-2000's internal clock by pressing [ENTER]. After checking to make sure that all
digital devices are properly connected and that the sample rates for all of the devices match, try this operation again.
■ Disk Memory Full!
There is insufficient free space on the disk. Erase unneeded data or select a different disk drive. The current disk partition
already contains 200 projects, the maximum number of projects it can hold. Delete unneeded projects or select a different disk
drive.
■ Drive Status Error!
The disk drive could not be accessed. Make sure that the disk drive is connected correctly.
■ Drive Time-out!
There is a problem with your disk drive connection. Make sure the disk drive is connected correctly.
■ Drive Unformatted!
The disk drive has not yet been initialized by the VS-2000. Initialize the disk drive.
If the disk drive has already been initialized by the VS-2000, there is a problem with its connections. Make sure that the disk
drive is properly connected.
■ Drive Busy!
If this message appears when you first begin using a disk drive with the VS-2000, the disk drive is not fast enough. You may
still be able to use this disk with projects that have a lower sample rate or use a different recording mode.
If this message appears after you have been using a disk drive with the VS-2000, the data on the disk drive has become
fragmented. This will unacceptably slow down the reading and writing of data. Try bouncing the current track to re-record its
data onto another track, or optimize your project. If this message still appears after these measures have been taken, copy the
project data to another disk drive and initialize the disk drive that experienced the problem.
9