Husqvarna 701 Enduro 2023 Owner's Manual page 121

Faults
Engine dies during the journey
ABS warning lamp lights up
High oil consumption
Headlight and parking light are
not functioning
Turn signal, brake light and
horn not functioning
Time is not (correctly) dis-
played
12 V battery discharged
Combination instrument shows
nothing in the display
Possible cause
Lack of fuel
Fuse 1, 2 or 3 blown
ABS fuse blown
Large difference in wheel
speeds of the front and rear
wheels
Malfunction in ABS
Engine vent hose bent
Engine oil level too high
Engine oil too thin (low viscosi-
ty)
Fuse 6 blown
Fuse 5 blown
Fuse 1 blown
Ignition not switched off when
vehicle was parked
The 12-V battery is not being
charged by the alternator
Fuse 1 or 2 blown
TROUBLESHOOTING 21
Action
–
Refuel. ( p. 42)
–
Change the fuses of individual electri-
cal power consumers. (
–
Change the ABS fuses. (
–
Stop the vehicle, switch off the igni-
tion, and start it again.
–
Read out the fault memory using the
Husqvarna Motorcycles diagnostics
tool.
–
Route the vent hose without bends or
change it if necessary.
–
Check the engine oil level. (
–
Change the engine oil and the oil filter,
clean the oil screens. (
–
Change the fuses of individual electri-
cal power consumers. (
–
Change the fuses of individual electri-
cal power consumers. (
–
Change the fuses of individual electri-
cal power consumers. (
–
Set the clock. ( p. 28)
–
Charge the 12-V battery.
–
Check the charging voltage.
–
Check the open-circuit current.
–
Change the fuses of individual electri-
cal power consumers. (
–
Set the clock. ( p. 28)
p. 92)
p. 90)
p. 108)
p. 108)
p. 92)
p. 92)
p. 92)
( p. 88)
p. 92)
119