Adjusting The Chain Tension; Checking The Chain, Rear Sprocket, Engine Sprocket, And Chain Guide - Husqvarna 701 Enduro 2023 Owner's Manual

12 SERVICE WORK ON THE CHASSIS
12.24
12.25
60

Adjusting the chain tension

Warning
Danger of accidents Incorrect chain tension damages components and results in accidents.
If the chain is tensioned too much, the chain, engine sprocket, rear sprocket, transmission and rear
wheel bearings wear more quickly. Some components may break if overloaded.
If the chain is too loose, the chain may fall off the engine sprocket or the rear sprocket. As a result, the
rear wheel locks or the engine will be damaged.
–
Check the chain tension regularly.
–
Set the chain tension in accordance with the specification.
V00509-10

Checking the chain, rear sprocket, engine sprocket, and chain guide

Preparatory work
–
Check the chain tension. (
Main work
–
1
Loosen nut .
–
2
Remove nuts on the left and right.
–
Adjust the chain tension by turning adjusting screws
and right.
Guideline
Chain tension
Turn the adjusting screws
the markings on the left and right chain adjusters
the same position relative to the reference marks
rear wheel is then correctly aligned.
Info
The top part of the chain must be taut.
Chain wear is not always even. Repeat this measure-
ment at different chain positions.
–
2
Tighten nuts .
–
Make sure that chain adjusters
3
adjusting screws .
–
1
Tighten nut .
Guideline
Nut, rear wheel spin-
dle
Preparatory work
–
Raise the motorcycle with a lift stand. (
p. 59)
5 mm (0.2 in)
3
on the left and right so that
4
A
4
are fitted correctly on
M25x1.5 90 Nm (66.4 lbf ft)
p. 50)
3
left
are in
. The