Adjusting The Basic Position Of The Foot Brake Lever; Checking The Rear Brake Fluid Level - Husqvarna 701 Enduro 2023 Owner's Manual

13.9

Adjusting the basic position of the foot brake lever

Warning
Danger of accidents The brake system fails in the event of overheating.
If there is no free travel on the foot brake lever, pressure builds up in the brake system on the rear
brake.
–
Set the free travel on the foot brake lever in accordance with the specification.
13.10

Checking the rear brake fluid level

Warning
Danger of accidents An insufficient brake fluid level will cause the brake system to fail.
If the brake fluid level drops below the MIN marking, the brake system is leaking or the brake linings
are worn down.
–
Check the brake system and do not continue riding until the problem is eliminated. (Your authorized
Husqvarna Motorcycles workshop will be glad to help.)
Warning
Danger of accidents Old brake fluid reduces the braking effect.
–
Make sure that brake fluid for the front and rear brake is changed in accordance with the service
schedule. (Your authorized Husqvarna Motorcycles workshop will be glad to help.)
–
Loosen fittings
–
To adjust the basic position of the foot brake lever to individ-
ual requirements, loosen nut
ingly.
Info
The range of adjustment is limited. The screw must
be screwed into the footrest bracket by at least four
turns.
–
Position foot brake cylinder
has the necessary free travel.
–
Tighten fittings
Guideline
Screw connection,
foot brake cylinder
–
Check the free travel of the foot brake lever. (
–
3
Tighten nut
S02167-10
BRAKE SYSTEM 13
1 2
on foot brake cylinder
3
and turn screw
2
so that the foot brake lever
1
.
M6 10 Nm (7.4 lbf ft)
.
.
4
accord-
p. 72)
73