Edirol UM-1 Owner's Manual page 18

• If the "File signature verification" setting is set to "Block," the "Digital Signature Not
Found" dialog box will appear during the installation; click the [OK] button. "Found
New Hardware Wizard" will appear, so click the [Finish] button to close the wizard,
and re-install as described in 'Is "? USB Device" shown in "Device Manager"?' (p. 35)
7.
Click the [OK] button to close "System Properties."
8.
Insert the UM-1 Driver CD-ROM into your CD-ROM drive.
9.
Click the Windows [Start] button, and select "Run..."
10.
When "Run" appears, input the following in the "Open" area.
* Change the drive name D: to match the drive name of your CD-ROM drive. For example if
your CD-ROM drive is named Q:, you would input "Q:\WIN2000\SETUPINF.EXE."
* If you do not know the name of the drive, click the [Browse] button to check the drive
name.
11.
After inputting the information, click the [OK] button.
* If a message saying that the file was not found appears, check the character string input in
the "Open" area once more.
12.
The "SETUPINF" dialog box will appear, and the display will indicate "Ready to install the
driver. ---"
13.
Connect the USB cable of the UM-1 to your computer.
* If in step 6 the "File signature verification" setting is not set to "Ignore," the "Digital
Signature Not Found" dialog box will appear. If this occurs, refer to "the caution given in
step 6," and take the appropriate action.
14.
The "Insert Disk" dialog box will appear. Click the [OK] button.
* If this dialog box does not appear, refer to 'The "Insert Disk" dialog box is not displayed in
"Installing the USB MIDI Driver".' (p. 37)
15.
The "Files Needed" dialog box will appear. In the "Copy files from" area, input
"D:\WIN2000" and click the [OK] button.
* Change the drive name D: to match the drive name of your CD-ROM drive. For example if
your CD-ROM drive is named Q:, you would input "Q:\WIN2000. "
* If you were not able to perform the installation according to this procedure, use the
procedure in "Tried other troubleshooting tips but the UM-1 still does not work" (p. 40) to
delete the driver, and then perform the installation once again.
16.
The "Found New Hardware Wizard" will appear. Make sure that "Roland UM-1 USB
Driver" is displayed, and click the [Finish] button.
18
D:\WIN2000\SETUPINF.EXE