Table of Contents
Advertisement
Hearthstone Quality Home Heating Products, Inc
TIMER MODE
(Appliance must be in
standby mode; pilot ignited)
The timers P1 and P2
(Program 1, Program 2)
each can be programmed to
go ON and OFF at specific
times. For instructions see
Timer Programming Mode.
.
NOTE: The display shows the set temperature
every 30 seconds.
SETTING ON/OFF TEMPERATURES
f i r e - p a r t s . c o m
SETTING THE "DAYTIME" TEMPERATURE
.
Briefly press SET
button to scroll to TEMP
(sun) mode. Once
there, hold the SET
button down until the
TEMP flashes.
Press
(large flame)
button to increase the
Daytime Set
Temperature or
press
(small flame)
button to decrease
Daytime Set
Temperature.
When finished, press
OFF or wait for remote
to re-set.
SETTING "NIGHTTIME SETBACK"
TEMPERATURE
.
Tip
Set the different parameters only when they are
flashing.
For the Nighttime setback mode, pressing
the down arrow until the LCD reads "- -" turns the
Nighttime Setback Temp feature off.
SETTING PROGRAM TIMERS
Program timer mode allows the user to program a
set time of day during which the appliance will
operate to maintain a preset temperature (the
Daytime Temp set above). When the appliance is
not operating within this programmed time, it will
revert to the Nighttime Setback Temp as
programmed above.
Default settings:
Program 1: P1
6:00 am
Program 2: P2
11:50 pm P2
ECLIPSE VF 8906
Briefly press SET
button to scroll to TEMP
(moon) mode. Once
there, hold the SET
button until the TEMP
flashes.
Press
(large flame)
button to increase the
Nighttime Set back
Temperature or
press
(small flame)
button to decrease
Nighttime Set
Temperature.
When finished, press
OFF or wait for remote
to re-set.
P1
8:00 am
11:50 pm
25
Advertisement
Table of Contents
