Table of Contents
Advertisement
Hearthstone Quality Home Heating Products, Inc
8. Press and hold the
flame only.
9. If the appliance will not operate, follow the instructions "TO TURN OFF GAS TO THE APPLIANCE" and call
your gas service technician or gas supplier.
TO TURN OFF GAS TO THE APPLIANCE
1. To turn off gas to the appliance, push
and release the
button on either the Remote Handset
or on the optional Wall Switch. You
will hear an audible signal confirming
the off setting.
2. TO TURN OFF THE GAS SUPPLY TO
THE APPLIANCE, close the shut-off
valve on the gas supply line to the
appliance.
OPERATING YOUR FIREPLACE FOR THE FIRST TIME
f i r e - p a r t s . c o m
When operating your new fireplace for the first time, some vapors may be released due to the burning of
curing compounds used in the manufacture of the appliance. They may cause a slight odor and could cause
the flames to be the full height of the firebox, or even slightly higher, for the first few hours of operation.
It is also possible that these vapors could set off any smoke detection alarms in the immediate vicinity.
These vapors are quite normal on new appliances. We recommend opening a window to vent the room. After
a few hours use, the vapors will have disappeared and the flames will be at their normal height.
FLAME SUPERVISION DEVICE
For your safety, this appliance is fitted with a flame supervision device which will shut-off the gas supply
if, for any reason, the pilot flame goes out. This device incorporates a fixed probe, which senses the
heat from the pilot flame. If the probe is cool, the device will prevent any gas flow unless manually
lighting the pilot. See full lighting instructions. Periodically check the pilot flame and compare to figure 2
above.
LIGHTING, OPERATION AND RATING INFORMATION
The Lighting, Operation and Rating
information is located on a plate under
the firebox.
To access the plate, remove any fret or
access panel and grab the plate and
slide it out to read it. There is important
information on both sides of the plate.
SERVICING
If any attention is required for your appliance, contact your dealer quoting the model number. It will be helpful
if the appliance's serial number can also be quoted. This number is on the rating plate, which is located under
the burner. The replacement parts are shown at the end of this manual. Please always quote the part
number and description when requesting spare parts.
button on the Remote Handset or optional Wall Switch to set the appliance to Pilot
"OFF"
ECLIPSE VF 8906
20
Advertisement
Table of Contents
