HearthStone AURORA 8906 Series Owner's Manual Installation And Operating Instructions page 21

Hearthstone Quality Home Heating Products, Inc
FIREPLACE CONTROL DEVICES
There are two ways to control your fireplace.
1. Thermostatic Remote Control
2. Optional Wall Switch
The Thermostatic Remote Control can be
programmed to function automatically—see pages
34-39.
The Wall Switch (optional) can be used to turn on,
off and to increase or decrease the flame height.
NOTE: The remote control in the AUTO mode
will override the optional wall switch.
HOW TO TURN YOUR FIREPLACE OFF (
Familiarize yourself with each of these
methods before operating your fireplace.
Handset and Wall Switch: Press and
f i r e - p a r t s . c o m
hold the OFF button for a second (either
on the handset or the wall switch).
If the flames are on, they go down and you
hear the valve motor wind down. You hear
a clunk and a beep indicating that the
valve has received the signal from the
remote control.
HOW TO ENSURE YOUR FIREPLACE CANNOT BE TURNED ON INADVERTENTLY
You can use the following method to ensure that your fireplace will not turn on when you don't want it on.
First, ensure your fireplace is turned off—including the pilot—and cold BEFORE going ahead.
· Close the shut-off valve on the gas supply line to the appliance.
· Remove all batteries from the receiver as well as the battery from the handset.
Automatic Shut-Off (in certain conditions)
Your fireplace's remote control is equipped with an automatic shut-off mechanism which is activated in
certain conditions. See page 28 in the Remote Control Operation section for a description of this feature.
NOTE: Before using the remote control system for the first time, the receiver and the handset are
synchronized at the factory. See the
section under Maintenance on page 30 of this manual if the receiver and handset lose synchronization.
IMPORTANT: BEFORE YOU BEGIN, please note that on this system, the settings of time, temperature
and automatic ON/OFF can only be programmed when the function display is flashing. Be patient
when programming as it can take a few seconds to set.
)
INCLUDING PILOT
Synchronizing the Remote and Valve Receiver Module
ECLIPSE VF 8906
21