Table of Contents
Advertisement
TROUBLESHOOTING
Issue
Computer not turning on after
plugging to power
Display E01
Display E03
Display E04 or E12
Display E06
Display E07
Solution
1. Please check if the overload protect jump, if yes, please
press it, let it continue to work.
2. Check if the wires of power switch, overload protect,
control board and the transformer are connected properly.
3. Remove the upright tube and check connection between
each wire, make sure each wire is plugged in properly. If
wires are damaged, please change the wire.
4. Check the transformer is working. If not, you will need to
change it.
Message Failure:
Probable Reason: The wires from computer and bottom
control board didn't connect well, please check each wire. If
the wire is damaged, then change the wires. If this does not
fix the issue, then change to a new transformer.
Inverter Overvoltage: Check if the power supply voltage is
abnormal and if it is 50% higher than the normal voltage.
Please use the correct voltage to check again.
Incline learning failed:
1. Check VR wire of incline motor is connected properly. If
not, reconnect VR to make it firm.
2. Check AC wire of motor is properly connected, and AC wire
of motor is inserted correctly on the control board.
3. Check connection line of motor for damage. If damaged,
then have it replaced. If cable is undamaged, then replace
the incline motor and press "learning" button of bottom
control board to relearn.
Inverter MCU problem:
The internal microcontroller of the inverter is faulty.
Please replace the inverter.
Inverter is too hot:
1. The temperature of the inverter is too high. Please stop
and rest for a period of time and restart.
2. The treadmill is overloaded and the current is too high,
causing an increase in the internal temperature of the
inverter. Please increase the lubricating oil.
TROUBLESHOOTING |
29
Advertisement
Table of Contents
