Table of Contents
Advertisement
Source Type = File or Playlist
Parameter
Type
Audio File
Disabled
Digital Level (dB)
Input channel mapping
Source Type = Audio input
Note that this case is not supposed to happen as this requires a backup MPX signal to be available on the transmitter site.
Parameters are the same as above, except the audio input that must be selected instead of a sound file or playlist.
When decoding an IP MPX stream, only an MPX input can be a backup source.
Once output programs have been defined, they are listed in the "Programs" page.
Type
Description
Read/Write
File or Playlist.
These files are stored locally on the internal DOM (disk on module).
Read/Write
Select the audio file or MPX file or playlist from the list.
Note that a sound file cannot be a backup to an IP MPX stream. The backup file must
be an MPX signal recorded at 192 kHz.
Read/Write
Set this parameter to "Yes" to disable this decoding priority.
Read/Write
Digital gain applied to the audio samples on this priority.
Read/Write
Select how the channels of the selected source are processed:
●
●
●
●
This should be set to "No" for MPX.
IQOYA X/LINK-MPX user manual
No: each input channel is assigned to an output channel.
Mix: the input channels are mixed to a single output channel. An attenuation of -6
dB is applied to each channel before they are mixed. The gain/attenuation set
through "Digital level" comes in addition to this attenuation.
First channel only: only the first channel is processed.
Second channel only: only the second channel is processed.
62
Advertisement
Table of Contents
