Table of Contents
Advertisement
Make sure all other devices connected to this LAN are in the same subnet and have different IP addresses (this includes the
PC from which you will connect to the IQOYA codec to configure).
WARNING:
●
Eth1, Eth2, Eth3 and Eth4 must belong to different subnetworks.
●
Eth1, Eth3 and Eth4 are Gbits interfaces.
●
Eth2 is a 100 Mbits/s interface.
6.3 Enabling / disabling the hardware bypass function
IQOYA X/LINK-MPX allows for the hardware bypass of the analog audio inputs to the analog audio outputs, and of the MPX
AES input to the MPX AES output in case of power supply failure.
6.4 Powering up IQOYA X/LINK
It is recommended to establish all connections before powering up the device.
IQOYA X/LINK features two internal hot swappable redundant power supply units. It is recommended to connect the two
power cords. However, only one cord may be used.
IQOYA X/LINK starts as soon as it is connected to the mains.
6.5 Steps to follow to configure IQOYA X/LINK
Set the global parameters of your IQOYA X/LINK
Encoding:
●
Adjust the parameters of the MPX input or analog audio inputs: type (analog, AES) and gain.
●
Declare the programs (encoding formats)
●
Declare the IP services to be streamed over IP (IP audio streams)
Decoding:
●
Adjust the parameters of the outputs: type (analog, AES), and gain.
●
Declare the IP services to be received from the network (IP audio stream)
●
Declare the output program(s)
●
Check the status and metrics on the output programs.
IQOYA X/LINK-MPX user manual
Enabling / disabling the hardware bypass
17
Advertisement
Table of Contents
