Commissioning; Transport And Unpacking - Beckhoff C9900-G00 Series Manual

4

Commissioning

To be able to use the push button extensions, you must first commission it. The first step involves
transporting and unpacking the control panel to which the push button extensions are mounted ex factory.
You will then need to access and wire the push button extension boards. Finally, commissioning takes place
in the TwinCAT System Manager.
4.1

Transport and unpacking

Note the specified transport and storage conditions (see Chapter 8 Technical data [} 39]).
Despite the robust design of the unit, the components are sensitive to strong vibrations and impacts.
Transporting a control cabinet with a panel installed can place too high an impact load on the control panel
and the mounted push button extension. During transport the device must therefore be protected from
excessive mechanical stress. Appropriate packaging of the panel, in particular the original packaging, can
improve the vibration resistance during transport.
Hardware damage due to condensation
Unfavorable weather conditions during transport can cause damage to the device.
• Protect the device against moisture (condensation) during transport in cold weather or in case of
extreme temperature fluctuations.
• Do not put the device into operation until it has slowly adjusted to the room temperature.
• Should condensation occur, wait for about 12 hours before switching the device on.
Unpacking
Proceed as follows to unpack the unit:
1. Check the packaging for transport damage.
2. Remove packaging.
3. Keep the packaging for possible future transport.
4. Check your delivery for completeness by comparing it with your order.
5. Check the contents for visible shipping damage.
6. In case of discrepancies between the package contents and the order, or in case of transport damage,
please inform Beckhoff Service (see Chapter 9 Service and Support [} 40]).
C9900-G00x and C9900-G02x
NOTICE
Version: 2.0
Commissioning
27