Table of Contents
Advertisement
Cabling and powering up the chassis
Cabling the chassis
After all system hardware is installed, cable the components.
WARNING: To reduce the risk of electric shock or injury due to high-current electrical energy, be
sure that all power is completely disconnected at the source before beginning any power
connections to the power bus bars or power bus box.
WARNING: Be sure that all circuit breakers are locked in the off position before connecting any
power components.
CAUTION: To avoid damaging the fiber cables, do not drape cables from one side of the rack to the
other and do not run cables over a hard corner or edge.
Procedure
1. Connect the network cables to the Ethernet ports on the I/O module (I/O module components on
page 14).
2. Connect a network cable to the iLO connector on the management module (Management module
components on page 13).
3. Connect the APM cable to the APM connector on the management module (Management module
components on page 13).
Installing the cable management arm
IMPORTANT: If you need to hinge the cable management arm on the rear right-hand side of the
rack, see the instructions in Converting the cable management arm for opposite side mounting.
Perform these steps to convert the arm to a right-hand swing and install the arm on the right side of
the rack.
Procedure
1. Install the rack rail brace.
Cabling and powering up the chassis
39
Advertisement
Table of Contents
Troubleshooting
