Installing The Chassis Into The Rack - HPE Apollo 4510 Gen9 Setup And Installation Manual

Installing the chassis into the rack

WARNING: Always have at least two people to lift the chassis into the rack. If the chassis is being
loaded into the rack above chest level, an additional person must assist with aligning the chassis
with the rails while the other people support the weight of the chassis.
WARNING: The chassis is very heavy. To reduce the risk of personal injury or damage to the
equipment:
• Observe local occupational health and safety requirements and guidelines for manual material
handling.
• Remove all installed components from the chassis before installing or moving the chassis.
• Use caution and get help to lift and stabilize the chassis during installation or removal, especially
when the chassis is not fastened to the rack.
WARNING: To avoid risk of personal injury or damage to the equipment, do not stack anything on
top of rail-mounted equipment or use it as a work surface when extended from the rack.
CAUTION: Always plan the rack installation so that the heaviest item is on the bottom of the rack.
Install the heaviest item first, and continue to populate the rack from the bottom to the top.
CAUTION: Hewlett Packard Enterprise has not tested or validated the chassis with any third-party
racks. Before installing the chassis in a third-party rack, be sure to properly scope the limitations of
the rack. Before proceeding with the installation, consider the following:
• You must fully understand the static and dynamic load carrying capacity of the rack and be sure
that it can accommodate the weight of the chassis.
• Be sure sufficient clearance exists for cabling, installation and removal of the chassis, and
actuation of the rack doors.
Installing the chassis 27