Installing The System Components Into The Chassis; Installing A Server - HPE Apollo 4510 Gen9 Setup And Installation Manual

Table of Contents

4. Press the Push tabs on each rail, and then slide the chassis into the rack. When the chassis stops

midway, press the push tabs on each rail to release the chassis and slide it fully into the rack.

CAUTION: Press and hold the "Push" tab on each rail until the chassis begins to slide into the

rack. Then, release the "Push" tabs and continue to slide the chassis into the rack. Press and

hold the "Push" tab on each rail again when the rails lock at a 76.2-cm (30-inch) extension.

Then, release the "Push" tabs again and finish sliding the chassis into the rack. Failure to

release the "Push" tabs may cause damage to the rails.

Installing the system components into the chassis

Once the chassis is installed in the rack, begin installing the components in the chassis.

CAUTION: To prevent improper cooling and thermal damage, do not operate the chassis unless all

bays are populated with a component or a blank.

Installing the chassis

Table of Contents