I/O Module Option Cabling; Hpe Smart Array P440 Controller Cabling - HPE Apollo 4510 Gen9 Setup And Installation Manual

3. Align and install the cable management arm on the right rack rail.

I/O module option cabling

The HPE Apollo 4500 system with its centralized HPE Smart Storage Battery supports up to two HPE
Smart Array controllers per node.
When an I/O module with the x16 riser option is installed, PCIe slot 2 is reserved for x16 options and the
HPE H240 Smart Host Bus Adapter options must be installed in PCIe slots 1 and 3.
This chassis supports one I/O module. Standard x8 I/O modules have four PCIe slots and one
FlexibleLOM slot while x16 I/O modules have four PCIe slots. Each PCIe slot has a power connector. For
power connector locations, see I/O module power connector identification on page 19.
This section describes the cable routing for the options installed in the I/O module.

HPE Smart Array P440 Controller cabling

The HPE Apollo 4510 Gen9 Chassis supports single and dual installation for the HPE Smart Array P440
Controller.
42 Cabling and powering up the chassis