MPP Solar PIP3624MAX User Manual page 33

Procedure
Step 1: Press and hold "
Step 2: Press " ", "
(detail descriptions in Step 3)..
Step 3: Please select setting program by following the procedure.
Program#
This function is to upgrade inverter firmware. If firmware upgrade is needed, please check with
:
Upgrade your dealer or installer for detail instructions.
firmware
This function is to over-write all parameter settings (TEXT file) with settings in the On-The-Go
:
USB disk from a previous setup or to duplicate inverter settings. Please check with your dealer
Re-write or installer for detail instructions.
internal
parameters
By pressing "
the selected function is ready, LCD will display "
confirm the selection again.
:
Press "

Export data
during the process. It will only display
log
this action is complete. Then, press "
screen.
Or press "

If no button is pressed for 1 minute, it will automatically return to main screen.
Error message for USB On-the-Go functions:
Error Code Messages
No USB disk is detected.
USB disk is protected from copy.
Document inside the USB disk with wrong format.
If any error occurs, error code will only show 3 seconds. After three seconds, it will automatically return to
display screen.
2. Timer Setting for Output Source Priority
This timer setting is to set up the output source priority per day.
Procedure
Step 1: Press and hold "
source priority.
Step 2: Press " ", "
descriptions in Step 3).
" button for 3 seconds to enter USB function setting mode.
" or " " button to enter the selectable setting programs
Operation Procedure
" button to export data log from the inverter to USB disk. If
" button to select "Yes", LED 1 will flash once every second
" button to select "No" to return to main screen.
" button for 3 seconds to enter Timer Setup Mode for output
" or " " button to enter the selectable programs (detail
". Press "
and all LEDs will be on after
" button to return to main
31
LCD Screen
LCD Screen
" button to
LCD Screen