Option Installation Flow Chart; Installing Options - Ricoh AP410 Setup Manual

Installing Options

*1
With Basic model, these cannot be installed at the same time.
*2
With Network standard model, these cannot be installed at the same time.

Option Installation Flow Chart

We recommend you install multiple options in the following order:
A
Attach the paper feed unit (Paper Feed Unit Type 400).
Attach the paper feed unit to the bottom of the printer.
You can attach up to two paper feed unit. Up to 1750 sheets of paper can be
loaded.
B
Attach the envelope feeder (Envelope Feeder Type 400).
Replace the paper tray of the optional feeder with the envelope feeder.
C
Install the SDRAM module (Memory Unit Type C).
Install the module to the SDRAM module slot on the controller board.
D
Install the 1394 interface unit, network interface board, 802.11b interface
unit or Bluetooth interface unit.
Install the 1394 interface unit, 802.11b interface unit or Bluetooth interface
unit on the controller board.
The 1394 interface unit and network interface cannot be used at the same
time.
Up to two of the following can be installed:
• Network Interface Board Type 2610
• 802.11b Interface Unit Type F
• 1394 Interface Unit Type 4510
• Bluetooth Interface Unit Type C
E
Install the hard disk drive (Hard Disk Drive Type 2600).
Install the hard disk drive to the controller board.
F
Install the Network Data Protection Unit Type B.
Insert the network data protection unit into the SD card slot on the controller
board.
G
Attach the duplex unit (AD450).
Attach the duplex unit to the rear of the printer.
Installing Options
Install options in the positions shown in the illustration.
36