Ricoh AP410 Setup Manual page 54

Installing Options
L
Fasten the controller board to the printer with the two screws.
❒ After finishing installation, you can check the network interface board is
properly installed: Print the configuration page from the "List/Test Print"
menu. If it is installed properly, you will see "Option Ethernet Board" for
"Controller Option".
❒ If the Network interface board is not installed properly, repeat the proce-
dure from the start. If you cannot install it properly even after reinstallation,
contact your sales or service representative.
For printing the configuration page, see p.33 "Test Printing".
54