Ricoh AP410 Setup Manual page 59

Installing Options
J
Match the controller board to the top and bottom rail using the "T" mark,
and then slide it into the printer slowly until it stops.
K
Push back the handle of the controller board until it clicks.
L
Fasten the controller board to the printer with the two screws.
❒ After finishing installation, you can check the 1394 interface unit is properly
installed: Print the configuration page from the "List/Test Print" menu. If it
is installed properly, you will see "IEEE1394" for "Controller Option".
❒ You need to make settings with the control panel before using the 1394 in-
terface unit. For more information, see p.99 "IEEE 1394 Configuration".
59