Installing Options; Available Options; Option List - Ricoh AP410 Setup Manual

Installing Options

Available Options

This section describes how to install options.
By installing options, you can improve the printer performance and have an ex-
panded variety of features to use. For the specifications of each option, see
Maintenance Guide.
• Before installing options, the machine should be turned off and unplugged
for at least an hour. Components inside the machine become very hot, and
can cause a burn if touched.
• Before moving the machine, unplug the power cable from the outlet. If the
cable is unplugged abruptly, it could become damaged. Damaged plugs or
cables can cause an electrical or fire hazard.
• When lifting the machine, use the grips on both sides. The machine could
break or cause an injury if dropped.
❒ The voltage rating of the connector for options is 24 V DC or less.

Option List

The following is a list of options for this printer. The network standard model
come with the ethernet port on the controller board as default.
Paper Feed Unit Type 400
Envelope Feeder Type 400
AD450 (Duplex Unit)
Memory Unit Type C (SDRAM Mod-
ule)
Hard Disk Drive Type 2600
Network Interface Board Type 2610
*1
1394 Interface Unit Type 4510
802.11b Interface Unit Type F
Bluetooth Interface Unit Type C
Network Data Protection Unit Type B
: Available option
- : Unavailable option
G1128605_0.00
Basic model Printer
*1 *2
*1 *2
*1 *2
-
Network standard model
Printer
-
Copyright © 2004
35