Network Setup - Ricoh AP410 Setup Manual

Configuration
N
Press the {U} or {T} key to display [DHCP], and then press the {# Enter}
key.

Network Setup:

DHCP
O
Press the {U} or {T} key to display [On], and then press the {# Enter} key.
DHCP:
*On
❒ "p" shows the current setting.
❒ After about two seconds, the display returns to the network setup menu.
P
If you use NetWare, select the frame type for NetWare.
Select one of the items below if necessary.
• Auto (Default)
• Ethernet II
• Ethernet 802.2
• Ethernet 802.3
• Ethernet SNAP
❒ Usually, use the default setting ("Auto"). When you first select "Auto", the
frame type detected by the printer is adopted. If your network can use more
than two frame types, the printer may fail to select the correct frame type if
"Auto" is selected. In this case, select the appropriate frame type.
Q
Press the {U} or {T} key to display [Frame Type (NW)], and then press the
{# Enter} key.
Network Setup:
Frame Type (NW)
The current setting appears on the display.
R
Press the {U} or {T} key to display the frame type you want to use, and
then press the {# Enter} key.
Frame Type (NW):
*Auto Select
91